Difference between revisions of "Reflow 0603 SMT components at Home"
From Hackteria Wiki
| Line 1: | Line 1: | ||
[[File:reflow_comparison_oldschool.jpg|400px]][[File:reflow_success_stabilized.gif|300px]][[File:reflow_01_setup.jpg|400px]] | [[File:reflow_comparison_oldschool.jpg|400px]][[File:reflow_success_stabilized.gif|300px]][[File:reflow_01_setup.jpg|400px]] | ||
| + | |||
| + | === Making the stencil === | ||
| + | |||
| + | [[File:reflow_laserCutStencil.jpg|400px]] | ||
| + | |||
| + | === Preparing for reflow === | ||
<gallery mode="packed-hover" heights=200px> | <gallery mode="packed-hover" heights=200px> | ||
| − | |||
File:reflow_01_setup.jpg | File:reflow_01_setup.jpg | ||
File:reflow_02_positionStencil.jpg | File:reflow_02_positionStencil.jpg | ||
| Line 9: | Line 14: | ||
File:reflow_04_smearPaste.jpg | File:reflow_04_smearPaste.jpg | ||
</gallery> | </gallery> | ||
| + | |||
| + | === Reflowing on small Hotplate === | ||
<gallery mode="packed-hover" heights=200px> | <gallery mode="packed-hover" heights=200px> | ||
Revision as of 13:24, 6 November 2022
Making the stencil
